3. 180 Conversion Kit – Corner to Straight #00617.18
INSTRUCTIONS:
1. Open dishmachine doors to their highest position so that there is
little spring resistance on the door handle. Remove hardware
holding the door handle to the door linkage. Save all the washers
and spacers. With the door handle in “UP” position, lift spring
and remove from extension rod. Remove the nut attaching the
eyebolt and save all hardware.
2. To remove the door handle, simply unscrew the four bolts holding
the door handle mounting plates and slide the complete assembly
up and off of the cabinet. Use the bolts, nuts and washers to plug
the holes in the back of the cabinet.
3. Remove door panel & hardware from left side of machine, and
install door guides from kit. Remove front door and relocate to
left side of machine. The service door will be used to seal off this
side of machine. Remove bolt located on top right hand corner of
the wrapper and use it to mount service door latch bracket.
Relocate tray track guide to front service door side of tray track.
4. Using provided nuts, bolts and washers; mount the left and right
door handle supports on the back of the cabinet. Insert the
eyebolts into the brackets on the back of the dishmachine stand
and screw the nuts on just enough to hold them in place. Hook
both door springs and door spring extension rods on to the door
handle and secure them with the washers and cotter pins. Then
simply rest the door handle on the door handle supports. (You
may have to lift the door handle to reach the handle supports.)
5. Swing the door handle downwards to reach the door linkages;
and using the two provided bolts and existing washers and
spacers, attach the door linkages to the door handle. Adjust the
tension in the spring by tightening the nuts under the eyebolt
bracket so that the doors can slide up and down freely. Mount
the provided door handle grips on the ends of the door handle.
6. Eyebolt adjustment nuts should be adjusted to the point the doors
begin to lift from a closed position. Both eyebolts should be
adjusted the same. SEE “Illustration #1” for the proper location of
all door handle hardware for CMA 180-S.
7. “Illustration #2” shows CMA 180-S and CMA 180-C door handle
assembly.
(40 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals