CMA Dishmachines CMA-180 VL Owner's Manual download pdf (Page 14)

MODEL CMA-180VL INSTALLATION & OPERATION Rev. 2.00 Page

3. Wiring Options

Wiring Options

3-Phase and 1 Phase

Single-Source

220V 3-Phase

(20 amp/12 g*)

(Without booster)

Single-Source

220V 3-Phase

(50 amp/8 g*)

Standard

Single-Source

220V 1-Phase

(80 amp/4 g*)

Two-Source

220V 1-Phase

(50 amp/8 g*)

(30 amp/10 g*)

Single-Source

220V 1-Phase

(30 amp/10 G*)

(Without booster)

DISPENSER HOOK-UP

1. The power signal is 208/230 volts. The power block is labeled inside the control box.

Conduit holes for both detergent & rinse are supplied on the control box.

2. A threaded (1/8”) injection point is provided on the final rinse Teflon mixing chamber

located off the back of the machine.

3. A (7/8”) hole is provided in the tank for a probe access. It is located on the front side of

the wash tank inside the heater cover.

MAIN POWER CONNECTION

Please refer to the machine data plate or choose one of the five (5) power connections illustrated

above. Electrical requirements are shown for machines with or without booster heater, three or

single phase.

WARNING: Insure that the machine is properly grounded and complies with all local and national

codes. Injury or death may occur from shock, if the machine is not properly grounded.

Install power supply wires, L1, L2 and L3 (3-Phase) to the appropriate terminals marked L1, L2,

and L3 on the power block. (If applicable, the high or “wild” leg must be connected to the L2

Terminal.)

*g=gauge

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

CMA Dishmachines CMA-180 VL Owner's Manual Page 14